Camera First Inspections is a mobile-only inspection mode that starts in the camera, not the form, so you capture, rate and annotate photos in one continuous flow. Use it to cut down on scrolling, tapping between fields and switching screens while you inspect on site.

🎬 Watch it in action: Watch: AI's first job: responsiveness

  Your inspection data works the same way

Photos, ratings, notes and markups sync just like a traditional inspection form. Nothing about your data changes, only the way you capture it.

Take the Camera First Inspections interactive tour →

Turn on Camera First Inspections in Manage

  1. Open Release Updates in Manage
    In Manage, go to Settings > Admin Center > Release Updates.
  2. Enable Camera First Inspections
    Enable Camera First Inspections.

Inspect with Camera First Inspections on mobile

1.  Open and start an inspection

Open an inspection on your mobile device and start it.

2.  Tap the camera icon

Tap the camera icon to open the camera-first experience. The inspection opens directly in camera view.

Tap the camera icon

3.  Apply ratings

Apply ratings as you normally would.

Apply ratings

  Tip

A check mark appears when the item is complete.

4.  Add notes

Tap the Notes icon next to the take photo button, type your note, then tap Done to save.

Add notes

  Tip

Notes work the same as in the original inspection experience.

5.  Exit the camera-first experience

Tap the back button to leave the camera-first experience. You can do this at any time.

Exit the camera-first experience

  Tip

Exit the camera-first experience before some actions, such as completing an inspection.

Was this article helpful?
1 out of 2 found this helpful